DocID023833 Rev 5 35/36
STM32F42xx and STM32F43xx Revision history
35
Revision history
Table 6. Document revision history
Date Revision Changes
11-Feb-2013 1 Initial release.
25-Feb-2013 2
Document converted to new template.
Added Section 2.8.4: Corruption of data read from the FMC
26-Apr-2013 3
Added Silicon revision Y.
Removed the reference to ‘Cortex-M4F’ in the whole document.
Updated Section 2.8.1: Dummy read cycles inserted when reading
synchronous memories.
Added Section 2.1.3: Wakeup sequence from Standby mode when
using more than one wakeup source, Section 2.7.5: Successive write
operations to the same register might not be fully taken into account
and Section 2.8.3: FSMC NOR Flash/PSRAM controller
asynchronous access on bank 2 to 4 when bank 1 is in synchronous
mode (CBURSTRW bit is set).
Removed limitation 2.10.3 SDIO clock divider BYPASS mode may
not work properly. Updated Section 2.9.5: No underrun detection
with wrong data transmission.
19-Sep-2013 4
Added STM32F429xx and STM32F439xx devices.
Removed FSMC limitations.
Added Section 2.3.5: Both SDA and SCL maximum rise time (tr)
violated when VDD_I2C bus higher than ((VDD+0.3) / 0.7) V.
Updated Section 2.8.5: Interruption of CPU read burst access to an
end of SDRAM row.
Added Section 2.8.1: Dummy read cycles inserted when reading
synchronous memories, Section 2.8.2: FMC synchronous mode and
NWAIT signal disabled, Section 2.8.3: Read access to a non-
initialized FMC_SDRAM bank, Section 2.8.4: Corruption of data read
from the FMC, Section 2.8.5: Interruption of CPU read burst access
to an end of SDRAM row, Section 2.8.6: FMC NOR/PSRAM
controller: asynchronous read access on bank 2 to 4 returns wrong
data when bank 1 is in synchronous mode (BURSTEN bit is set) and
Section 2.8.7: FMC dynamic and static banks switching.
Added Figure 1: TFBGA216 top package view, Figure 2: WLCSP143
top package view, and Figure 3: LQFP208 top package view.
23-Sep-2013 5
Updated workaround in Section 2.8.6: FMC NOR/PSRAM controller:
asynchronous read access on bank 2 to 4 returns wrong data when
bank 1 is in synchronous mode (BURSTEN bit is set).
To Next Page
Loading...
Need help?
General
