4 | Transport and storage
14
07/2023 | ID 443360_en.00
4.2.1 Long-term storage
If you would like to store the drive for longer than 6 months, take the following steps to prevent corrosion damage:
1. Apply a suitable corrosion protection agent to unpainted surfaces, such as shaft ends or flange contact surfaces.
2. Completely fill the gear unit with lubricant. The lubricant specification can be found by entering the serial number of
the gear unit at https://id.stober.com or by scanning the QR code on the nameplate of the gear unit.
Before commissioning the gear unit, reduce the lubricant fill volume to the fill volume that is specified on the nameplate of
the gear unit.
To Next Page
Loading...
General