22
If the tank is full of salt it is difficult to know whether there is
a salt bridge, since the salt on the surface may seem loose,
even if the lower part is solid.
In order to check the existence of a salt bridge, take a long
rigid tool (e.g. a broom handle) and keep it next to the water
softener to measure the distance from the floor up to the salt
edge. Then put the tool in the salt. If there is a hard object, it
may be a salt bridge.
Apply carefully some pressure on several places until it breaks.
‘WARNING’ Do not use sharp or pointed objects, since they
could damage the water softener tank.
Press
Salt
Salt
Bridge
Water
level
HYGIENISATION: It is recommended to carry out an hygieni-
sation process once per year, as indicated below:
1. Open the deck of the salt tank and pour between 20 to 30
ml (2 or 3 caps) of Bacwater (652100) inside the brine chim-
ney. Close it again.
2. Check that the by-pass valve is in service.
3. The disinfection process will be carried out after the rege-
neration and the disinfecting solution will be sent to the drain.
Inner
chimney
ANTI-SCALING: Once per year it is recommended to clean
the water softener with Clean Softener (611000). This product
has been designed to clean and descale your water softener.
This product, due to its special formula, cleans the resin by
removing iron residues and other metals which might pollute
it. It also removes possible scaling on the inner holes of the
valves.
Inner
chimney
SINGLE-DOSE
NOTE: Carefully follow the instructions for use provided on
the labels of the product.
The maintenance and hygienisation of the system must be
carried out by skilled technical personnel under the proper
hygienic conditions and following the specific instructions of
each product.
To Next Page
Loading...
