Streamit Lisa LCD - 11.4 Command overview list

Lisa LCD 77
The Telnet feature on the Lisa is not protected by a username and/or password. Be careful when
making the Lisa accessible from outside the local area network.
11.4 Command overview list
The list below presents all available commands for the Lisa. Examples of using these commands are
given in Examples of sending commands, links to these examples are offered in the overview below as
well.
By default the Lisa sends a response when it receives a command. In case the Lisa is required to report
a setting, it will send these settings back. In case the Lisa is required to change a setting, it will respond
with an “OK” when successful. When the Lisa fails to execute the command, it will send “ERROR” back.
Some commands are protected by a password, this password is 'streamit' (without quotes).
For most settings it is required that the device is reset to apply changes to settings. The Lisa
Configuration Tool always will send the <reset> command after it has program settings to the device.
Description
Command
Parameter 1
Par.
2
Parameter 3
Announcement start
sa
Filename of the
announcement on the SD
card
Audio chip registers
vshow
Audio chip type
vstype
Audio source
(example)
audiosource
"inet", "card"
Bass level
bass
0 to 15
Cleanup card
cc
Clear scheduled
tasks
ct
Commercial start
sc
Filename of the
commercial on the SD
card
Configuration URL
(example)
isp
password
7
Configuration URL (maximum
length 144 characters)