9
Chapter IV
Initial Setup
A. Introduction
For those settings which are seldom changed during operation of the T-Mike E the INITIAL SET UP
procedure is designed to allow the operator
access to those settings without unnecessary complication of the units normal operation.
These settings include:
Backlight on/off
Selection of Metric or English units of measure
Calibration Lock
The INITIAL SET UP procedure is accessed by holding the CAL key down and pressing the ON/OFF key.
When this is done the T-Mike E will display the version code of the operating software contained in the unit
until the CAL key is released. This information will be useful should the unit require service or updated
software is desired.
Upon release of the CAL key the SETUP procedure continues as follows:
B. Backlight On/Off
When the CAL key is first released the T-Mike E will display the words ON or OFF to indicate the status of the
backlight. The backlight setting can be selected by pressing the UP or DOWN arrow key.
To Next Page
Loading...
