Strobel 4 - Page 5

1 MA_560_A4_180619_en
Mechanic’s instructions
STROBEL series 560
Contents
1 General notes on safety ............................................................................................ 5
2 General ..................................................................................................................... 7
2.1 Operating instructions ..................................................................................... 7
2.2 Class identification, serial number and orientation of the machine ................. 7
2.3 Range of application and intended use .......................................................... 7
2.4 Technical Data ................................................................................................ 8
2.5 Summary of setting instructions ..................................................................... 8
3 Instructions for repair and settings ............................................................................ 9
3.1 Mounting the needle plate .............................................................................. 9
3.1.1 Removing the needle plate (Fig. 1) .................................................... 9
3.1.2 Remounting the needle plate ............................................................. 9
3.1.3 Setting the needle plate (Fig. 1 and Fig. 2) ...................................... 10
3.1.4 Setting the needle (Fig. 1) ................................................................ 11
3.1.5 Changing the needle glide plate (Fig. 1) .......................................... 11
3.1.6 Thread holder ................................................................................... 11
3.1.7 Setting the thread holder (Fig. 1) ..................................................... 11
3.2 Setting the needle lever ................................................................................ 12
3.2.1 Lateral setting of needle lever (Fig. 3 and Fig. 4) ............................. 12
3.2.2 Setting of the needle lever in relation to the thread take-up (Fig. 5) 13
3.2.3 Setting the stitch width (Fig. 6) ......................................................... 14
3.3 Loop stroke ................................................................................................... 14
3.3.1 Setting the loop stroke (Fig. 5) ......................................................... 14
3.4 Looper .......................................................................................................... 15
3.4.1 Removing and remounting the looper (Fig. 7) .................................. 15
3.4.2 Setting the looper ............................................................................. 15
3.4.3 Tension of V-belt for looper drive (Fig.9) .......................................... 15
3.5 Thread take-up ............................................................................................. 16
3.5.1 Thread take-up movement (Fig. 8) ................................................... 16
3.5.2 Upper thread tension (Fig. 9) ........................................................... 17
3.5.3 Lower thread tension (Fig. 9) ........................................................... 17
3.5.4 Setting the thread wiper (Fig. 10) ..................................................... 18