21 BA_VEB200-1-2_A2_180618_en
5
It is recommended to equip the machine with a pneumatic lifting device to
facilitate machine handling (please see “8.3 Pneumatic lifting”).
Operating the machine
ATTENTION!
Please observe the sewing area carefully during sewing.
Otherwise DANGER of finger bruises and needle through
stitches.
5.1
Connect the compressed-air conditioner to the compressed air supplier (10 bar)
or to the compressor and set it to 6 bar.
Switch on main switch on the right hand side under the table top, control lamp
in the “OFF“switch lights red.
On machines with pneumatic lifting now the material support arm is open, the
machine is ready to sew.
Switching on
To Next Page
Loading...
