24 BA_VEB200-1-2_A2_180618_en
Fig. 6
Fold the fabric in S-shape in the desired seam width (Fig. 7 and Fig. 8), insert it
and make sure that the feed dog catches the beginning of the seam after the
first stitch.
Operate the treadle briefly.
Sew the piece and re-adjust above settings until you get the desired result.
Readjust the stitch depth regulation if the stitches show through on the outer
fabric side.
Sometimes certain “marks“caused by the needle penetration on the outside of
the fabric cannot be avoided when the fabric is extremely thin or hard.
Make sure that during sewing the hem edge is always guided along the material
guide. Avoid sudden treadle operations since speed changes during the sewing
process may influence the needle penetration.
To Next Page
Loading...
