9
3.1
Directly when you select Air and press button. Auto channel searching for channels is started. Just wait until all channels are
found. Now you can enjoy digital Tv.
If no channels are found, check antenna connection, or check if arial is correct adjusted to transmission tower. Start from
beginning the installation trough menu/ option/ Installation Guide.
3.2
After you select Cable and press button. The Cable Scan Menu will open. In this menu you can select Full for automatically
searching for channels if you do not know the details of you local provider. Select Network Search to install the channels list in
sorted channel order from local provider.
Cable Setting
Press to highlight your settings.
Scan type You can select Network Search or Full.
Network ID The default setting is Auto. To enter your own value press and enter (with 0 ~ 9) the used Network ID from
your provider.
Frequency The default setting is Auto. To enter your own value press and enter (with 0 ~ 9) the main frequency used
by your provider in KHz.
Symbol Rate The default setting is Auto. To enter your own value press and enter (with 0 ~ 9) the used Symbol Rate
from your provider. (Ks/s) most used values are 6900 or 6875.
After selection is made, press ENTER Auto channel searching for channels is now started. Just wait until all channels are found.
Now you can enjoy digital Tv.
If no channels are found, check antenna connection, or check if correct values of network are entered. Start from beginning the
installation trough menu/ option/ Installation Guide.
NOTE: Please, check the settings for your cable system used by your provider! Full scan will have a duration of
approximately 20 minutes, depending on your cable network.
3.3
Select Satellite press button to proceed installation for channels from satellite.
If you have selected country Germany or Austria , then Channel Preset menu will open. Select if you like load a pre-installed
channel list ready to use or proceed with Auto Channel search as for all other countries.
Select Auto Channel Search to open Satellite Setup menu.
Use ENTER button.
use to highlight the options of you dish antenna installation.
Select LNB type to select your used LNB type in the dish antenna. (Most common is 09750/10600).
Select DiSEqC 1.0 or 1.1 if your installation is using switch for selection of more satellite dishes.
(Most common is to set DiSEqC 1.0 to LNB 1 port).
Select Motor for the satellite specialist how are using motor to receive multiple satellites.
If all setting and selection are made, press BLUE Scan button to open next menu Channel Search.
Scan Mode Choose between Default (recommended) and Blind Scan
Encrypted type Select FTA channels to search Free-To-Air channels only.
Select Encrypted to search scrambled /coded channels only.
Select All to search all channels.
Service Type Select All to search Digital TV channels and Radio.
Select DTV for only Digital TV channels.
Select RADIO to search radio channels only.
It is recommended to use the default settings.
ENTER button to start auto searching of channels. Just wait until all channels are found. Now you can enjoy digital
Tv. If no channels are found, check antenna connection, or check if correct values of network are entered. Start from beginning
the installation trough menu/ option/ Installation Guide.
To Next Page
Loading...
Need help?
General
