10
4.0
broadcasted programmes. You can access it in digital mode by pressing EPG on the remote control. Press EPG to bring up the EPG
interface. Use to select a channel.
Press INDEX to switch to overview from one channel EPG. Use to select event where you like to know more details. Press
EXIT to stop and return to viewing modes.
Then press the COLOUR BUTTONS for entering the required settings.
GREEN Information
YELLOW Schedule List
BLUE Set a reminded to event or set even Timer function.
5.0 MENU SETTINGS
Below items depend if they are available of select input source. Use SOURCE to select other source. Selections are DTV, ATV,
HDMI, AV, and USB Media.
5.1
Press MENU to enter the main menu. Press to select an item. Press ENTER to select the submenus. Press MENU to exit the
item.
5.2 CHANNEL
Press MENU to display the main menu. Press ENTER to select Channel in the main menu. Press to select the option you wish
to adjust in the Channel menu.
Press ENTER MENU to save and return to the previous menu. Below items
depend if they are available of select input source. Use SOURCE to select other source.
5.2.1 ANTENNA TYPE
Press ENTER to select which antenna type you want to use. Select between, Air, Cable or Satellite.
5.2.2 AUTO TUNING
Press
to select Auto Tuning. If the TV use DVB-T or DVB-C tuner please refer to chapters 3.1 and 3.2; for Satellite (DVB-S) tuner
please refer to chapter 3.3.
5.2.3 DISH SETUP
If you use Satellite as input source, the Dish Setup menu allow you to set you satellite and belonging settings as DiSEqC port and
LNB type. Afterwards you may start the Auto Tuning with the BLUE Scan button or Manual Tuning by selecting with INDEX button
the wanted transponder.
5.2.4
Search and store programmes manually. Press to select DTV Manual Tuning. Then press ENTER to enter the sub-menu.
Press
to select a Channel No., and then press ENTER to start the search. The search stops when a programme is found and this
programme will be stored in the current channel position. Press MENU to exit.
5.2.5
In the Channel menu, select ATV Manual Tuning and press ENTER to access. Highlight and press to select Storage To 1 (maybe
other number), Sound System and Channel No.. Then select search and press ENTER to start the search. Press for the unit to
search towards higher frequency. Press for the unit to search towards lower frequency. The search stops when a programme is
found and this programme will be stored in the current channel position. If you want to stop the search, press MENU.
Sound Standard Select the Sound standard.
Video Standard Select the Video standard (Available: AUTO, PAL, NTSC, SECAM)
Current CH Set the channel number.
Search Start the channel search.
Fine-Tune Adjust the frequency of the channel.
To Next Page
Loading...
Need help?
General
