4
Introduction
The Cast Cutter is intended to section and remove plaster and synthetic casts.
Read and understand the information in this manual. Familiarization with the Stryker Cast Cutter prior to use is important.
For further information contact your Stryker Instruments Representative or call Stryker Customer Service at (800) 253-3210.
(Outside the USA, contact your nearest Stryker Subsidiary.)
WARNING: Prior to use the Stryker Cast Cutter and blades should be operated and inspected for any damage. DO NOT use
if damage is apparent.
REF 940 Cast Cutter, 100-120V unit
REF 941 Cast Cutter, 220-240V unit
Symbol Definition
A lightening bolt within a triangle is intended to alert service personnel of the presence of dangerous voltage that may
cause injury or fatal electrical shock. Disconnect unit from electrical supply before servicing.
An exclamation point within a triangle is intended to alert the user to the presence of important operating and
maintenance (service instructions) in the literature accompanying the products.
ON/STANDARD OPERATING SPEED
STANDBY The device is not operational, although the
electrical power is still connected.
ON/HIGH SPEED
DOUBLE INSULATION
TYPE BF Applied Part
I
II
To Next Page
Loading...
Need help?
General
