Stryker Performance-PRO XT Operation Manual

RRaaiissiinngg oorr lloowweerriinngg tthhee ccoott wwiitthh oonnee ooppeerraattoorr
You can raise or lower an unoccupied cot into a vehicle with one operator.
WWAARRNNIINNGG
• Always keep hands, fingers, and feet away from moving parts. Use caution when placing your hands and feet near the
base tubes while you raise or lower the cot.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you load or
unload the cot or change cot height position.
• Always remove your foot from the base tube when you are lowering the cot to the lowest position.
• Always keep hands away from the foot end release handle when you raise or lower the cot with the side release handle.
To raise or lower the cot:
From the foot end From the side
1. Grasp the lower foot end lift tube.
2. Tip the cot up on its load wheels.
3. Squeeze and hold the release handle and raise or lower
the cot.
4. Release the release handle when you reach the desired
height.
5. Lower the cot back on onto the four base wheels.
1. Place one foot on the outer base tube.
2. Grasp the side release handle with one hand. Place
your other hand on the outer support rail to stabilize the
cot.
3. Squeeze and hold the release handle and raise or lower
the cot.
4. Release the release handle when you reach the desired
height.
LLooaaddiinngg oorr uunnllooaaddiinngg aa ccoott wwiitthh tthhee PPoowweerr--LLOOAADD ooppttiioonn
The cot is fully compatible with the Model 6390 PPoowweerr--LLOOAADD system if you ordered the cot with the PPoowweerr--LLOOAADD option
or upgraded your cot with the compatibility kit.
WWAARRNNIINNGG
• Always use PPoowweerr--LLOOAADD with the 6085/6086 PPeerrffoorrmmaannccee--PPRROO XT, 6500/6506 PPoowweerr--PPRROO XT, and 6510/6516
PPoowweerr--PPRROO IT cots with the PPoowweerr--LLOOAADD option only. In certain situations, you can use PPoowweerr--LLOOAADD as a standard
antler for most X-frame cots, but a rail clamp assembly is required for all cots without the PPoowweerr--LLOOAADD option.
• Always make sure that you use a PPoowweerr--LLOOAADD date of manufacture cot with the Stryker Model 6390 PPoowweerr--LLOOAADD
system to avoid the risk of injury.
CCoott CCoommppaattiibbiilliittyy kkiitt
Model 6506 PPoowweerr--PPRROO XT 6506-700-001
Model 6516 PPoowweerr--PPRROO IT 6516-700-001
Model 6086 PPeerrffoorrmmaannccee--PPRROO XT 6086-700-001
For more information about using your PPoowweerr--LLOOAADD compatible cot, see the PPoowweerr--LLOOAADD Operations Manual.
EN 22 6086-209-001 Rev F.2

Stryker Performance-PRO XT Specifications

General

Brand	Stryker
Model	Performance-PRO XT
Category	Medical Equipment
Language	English