2
to potential problems with secure connections or electromagnetic
compatibility. Use the provided HDMI high speed cable (or other Stryker-
approved HDMI cable) with the SYNK® 4K Wireless System.
11. Only connect items that have been speci ed as part of the SYNK® 4K
Wireless System or that have been speci ed as being compatible with the
system.
12. To avoid the risk of electric shock, this equipment must only be
connected to a supply mains with protective earth.
13. Do not place any heavy object on the power cord. Damage to the power
cord can cause re or electric shock.
14. Do not put any liquid or solid object into the device. If this occurs, unplug
the device and have it checked by quali ed personnel before operating it
any further.
15. Use appropriate caution to prevent contact with uids if the receiver or
transmitter is being used with a power supply in patient environments.
16. To avoid electric shock, do not open the receiver or transmitter housings.
17. Do not modify this equipment without authorization of the manufacturer.
18. Attempt no internal repairs or adjustments not speci cally detailed in this
operating manual. Refer any adjustments, modi cations, and/or repairs to
Stryker Endoscopy or its authorized representatives.
19. Do not touch the device and a patient simultaneously, as there is a risk of
electric shock.
20. Do not touch the patient with signal input or output connectors.
Equipment with SIP/SOP connectors should either comply with
IEC60601-1 harmonized national standard or the combination should be
evaluated for safety.
21. For optimal operation of the SYNK® 4K Wireless System, leave a
minimum of 1m (3.3 ft) between any part of the System and portable RF
communications equipment.
22. To prevent tampering, physically secure the device when not in use.
Cautions
To avoid potential damage to this device, please note the following cautions.
1. Carefully unpack the system and check if any damage occurred during
shipment. If damage is detected, refer to the warranty.
2. Do not install the devices near sunlight, excessive dust, mechanical
vibration, or shock.
3. Keep the devices away from equipment that uses strong magnets (i.e.,
large loudspeakers).
To Next Page
Loading...
Need help?
General
