Stryker SYSTEM G 7305-001-000 - Attachment and Safety Switch Details; Safety Switch Modes; Wire and Pin Collet Operation; Keyed Chuck Operation

6 www.stryker.com
EN 7305-001-700 Rev-A
Safety Switch
Forward Mode – Only the forward
trigger is functional. The reverse
trigger is locked to prevent
inadvertent operation of the
handpiece in a counterclockwise
direction.
Forward/Reverse Mode – Both
triggers are functional.
Safe Mode – Both triggers are
locked to prevent inadvertent
operation of the handpiece.
Attachments
Wire and Pin Collets
C
B
A
A Clamping Lever – Secures and releases the
wire or pin from the attachment.
B Pre-adjust Knob – Allows the collet to
receive wires and pins of various diameters.
C J-Notch – Secures the attachment in the
handpiece.
Keyed Chucks
A
C
B
A Jaws – Secure the cutting tool in the
attachment.
B Chuck Key – A tool used to open and close
the jaws.
C J-Notch – Secures the attachment in the
handpiece.
Keyless Chucks
C
BA
D
A Lock Switch – Locks the collar to prevent
inadvertent operation of the attachment (REF
4103-133-000 only).
B Chuck – Rotates to open and close the
jaws.
C Jaws – Secure the cutting tool in the
attachment.
D J-Notch – Secures the attachment in the
handpiece.