SSeettuupp
CCAAUUTTIIOONN
• Do not use the product for CPR procedures, X-ray procedures, or with a defibrillator.
• Do not use the product in an oxygen-rich environment, such as an oxygen tent.
• Always allow the product to reach operating temperature before conducting any setup or testing functional operations to
prevent permanent product damage.
• Always operate the product when all operators and occupants are clear of the mechanisms.
• Always properly handle the power cord to avoid the risk of entanglement, damage to the power cord, or potential shock
hazards. If the power cord is damaged, immediately remove the product from service and contact the appropriate
maintenance personnel.
• Always plug the product directly into a properly grounded hospital-grade or medical-grade wall outlet to achieve
grounding reliability.
Before you place the product into service, make sure that these components are working properly:
1. Visually inspect the product for any signs of shipping damage.
2. If your product is equipped with the battery backup option, make sure that the battery on/off switch (|/O) (A) is turned on
(|) before you plug the power cord into a wall outlet.
NNoottee -- If the battery on/off switch (|/O) is set to O, then the battery backup option is off. If the battery on/off (|/O) switch is
set to |, then the battery backup option is on.
3. Plug the power cord into a wall outlet.
4. Allow the batteries to fully charge before using the product function on battery power only.
5. Make sure that the power indicator illuminates on the operator control panel and the service indicator is not illuminated
(
Operator control panel
(page 14)).
FFiigguurree 22 –– BBaatttteerryy oonn//ooffff ((|//OO)) sswwiittcchh
EN 10 3333-009-001 Rev H.1
To Next Page
Loading...
Need help?
General
