EEMMCC iinnffoorrmmaattiioonn
CCAAUUTTIIOONN
• The use of accessories, transducers, and cables, other than those specified or provided by the manufacturer, could
result in increased electromagnetic emissions or decreased electromagnetic immunity and result in improper operation.
• The emissions characteristics of this equipment make it suitable for use in industrial areas and hospitals (CISPR 11
class A). If it is used in a residential environment (for which CISPR 11 class B is normally required) this equipment might
not offer adequate protection to radio-frequency communication services. The user might need to take mitigation
measures, such as relocating or re-orienting the equipment.
GGuuiiddaannccee aanndd mmaannuuffaaccttuurreerr’’ss ddeeccllaarraattiioonn -- eelleeccttrroommaaggnneettiicc eemmiissssiioonnss
TTrruuRRiizzee is intended for use in the electromagnetic environment specified below. The customer or the user of TTrruuRRiizzee
should assure that it is used in such an environment.
EEmmiissssiioonnss tteesstt
CCoommpplliiaannccee EElleeccttrroommaaggnneettiicc eennvviirroonnmmeenntt
RF Emissions
CISPR 11
Group 1
TTrruuRRiizzee uses RF energy only for its internal
function. Therefore, its RF emissions are very
low and are not likely to cause any
interference in nearby electronic equipment.
RF Emissions
CISPR 11
Class A
TTrruuRRiizzee is suitable for use in all
establishments other than domestic and those
directly connected to the public low-voltage
power supply network that supplies buildings
used for domestic purposes.
Harmonic Emissions
IEC 61000-3-2
Class A
Voltage Fluctuations
Flicker Emissions
IEC 61000-3-3
Complies
CCAAUUTTIIOONN
• Portable RF communications equipment, including peripherals such as antenna cables and external antennas, should
be no closer than 12 inches (30 cm) to any part of TTrruuRRiizzee, including cables specified by the manufacturer.
• Avoid stacking or placing equipment adjacent with other equipment to prevent improper operation of the products. If
such use is necessary, carefully observe stacked or adjacent equipment to make sure that they are operating properly.
RReeccoommmmeennddeedd sseeppaarraattiioonnss ddiissttaanncceess bbeettwweeeenn ppoorrttaabbllee aanndd mmoobbiillee RRFF ccoommmmuunniiccaattiioonnss eeqquuiippmmeenntt aanndd TTrruuRRiizzee
TTrruuRRiizzee is intended for use in an electromagnetic environment in which radiated RF disturbances are controlled. The
customer or the user of TTrruuRRiizzee can help prevent electromagnetic interferences by maintaining a minimum distance
between portable and mobile RF communications equipment (transmitters) and TTrruuRRiizzee as recommended below,
according to the maximum output power of the communications equipment.
RRaatteedd mmaaxxiimmuumm oouuttppuutt
ppoowweerr ooff ttrraannssmmiitttteerr
W
SSeeppaarraattiioonn ddiissttaannccee aaccccoorrddiinngg ttoo ffrreeqquueennccyy ooff ttrraannssmmiitttteerr
m
115500 kkHHzz ttoo 8800 MMHHzz
DD==((11..22)) ((√√
PP
))
8800 MMHHzz ttoo 880000 MMHHzz
DD==((00..3355)) ((√√
PP
))
880000 MMHHzz ttoo 22..77 GGHHzz
DD==((00..7700)) ((√√
PP
))
0.01 0.12 0.12 0.23
EN 24 3333-009-001 Rev H.1
To Next Page
Loading...
Need help?
General
