Strymon Big Sky MX - Dry Signal and Spillover Options

pg 53
Global Setting Values Description
EXP Mode
EXP MODE
Pedal
Bank
Preset
MIDI
Allows configuration of the BigSky MX’s EXP
jack to connect the desired type of controller
device and its functionality:
• Pedal (default) - For the use of an
Expression Pedal (25K Ohm potentiometer
minimum) to control BigSky MX’s knobs�
• Bank - For the use of a Strymon
MultiSwitch or MultiSwitch Plus to access
Bank Down, Preset A/B Toggle, and Bank
Up�
• Preset - For the use of a Strymon
MultiSwitch or MultiSwitch Plus to access
Preset Down, Bypass, and Preset Up�
• MIDI - For the use of TRS MIDI for MIDI CC/
PC messages, or for a Strymon MultiSwitch
Plus to access Presets 0B, 1A, & 1B�
Please see page 55 for setup details�
Dry Signal
DRY SIGNAL
Normal
KillDry
Allows the dry signal to be turned on or off�
This is useful in a parallel effects loop or mixer
send where an effect level may be necessary�
• Normal (default) - The dry signal is routed
to the outputs�
• KillDry - Mutes the dry signal, allowing the
MIX control to be used as an effect (wet
only) level�*
*NOTE: When KillDry is selected, BigSky MX
is automatically set to Buffered Bypass—see
"Bypass" on page 49�