Need help?Do you have a question about the Strymon NIGHTSKY and is the answer not in the manual?
Removes low end content from the reverb.
Removes high frequency content from the reverb.
Selects the response of the HIGH CUT knob.
Adjusts the filter Q or sharpness of the resonant frequency.
Adjusts the reverb decay time.
Selects one of three different reverb types.
Adjusts time between dry signal and reverb onset.
Increases the size of the reverb core for a larger space.
Selects response and range of SIZE/PITCH knob.
Selects one of eight scales for SIZE/PITCH quantization.
Selects pitch interval of the shimmer effect.
Selects the type of shimmer effect.
Sets the amount of the shimmer effect.
Enhances harmonic spectrum of input signal.
Adds saturated overdriven harmonics to reverb.
Adjusts the rate of modulation.
Selects the process modulation is applied to.
Selects the shape of the modulating waveform.
Adjusts the amount of modulation.
Sets the output level of the reverberated signal.
Sets the output level of the dry signal.
High impedance ultra low-noise preamp inputs.
Low impedance stereo outputs.
Sets the input level to effect processing.
Full featured 5-pin DIN MIDI input.
General| Current Draw | 300mA |
|---|---|
| Weight | 1.5 lbs |
| Effects | Reverb |
| Inputs | Stereo input (2 x 1/4") |
| Outputs | Stereo output (2 x 1/4") |
| MIDI | In/Out via TRS 1/4" |
| Power | 9V DC (300mA minimum) |
| Bypass | True Bypass |
| Technology | Digital |
| Presets | 300 |
| Algorithms | Reverberator |
| Type | Reverberator |
| Controls | Decay, Size, Tone, Modulation, Drive, Mix |
To Next Page
