Strymon NIGHTSKY - PROGRAMMING A SEQUENCE

NightSky - Time-Warped Reverberator
pg 22
PROGRAMMING A SEQUENCE
TIP: It is helpful to have audio in the reverb
buffer while you program the sequence.
This can be done by playing audio through
the pedal or holding the audio using the
INFINITE footswitch.
TIP: Try setting QUANTIZE to half step or
scale for more harmonious sequences.
Press a PRESET BUTTON to enable (AMBER button LED) or
disable (button LED OFF) the sequence step. A maximum of
eight steps can be active for the sequence.
Press and hold a PRESET BUTTON and turn the SIZE/PITCH
knob to set the desired pitch for each sequence step.
A minimum of two active steps are required for the sequence
to run.
1
2
DRYLOW CUT HIGH CUT INTERVAL SHIMMER
REVERBSPEED DEPTH LENGTH SIZE
/ PITCH
rand
env
-8va
-5th
-2nd +2nd
+5th
+8va
-4th +4th
TARGET
FILTER GLIMMER DRIVESHIMMER
SHAPE TEXTURE QUANTIZE
pre
post
smooth
half step
scale
verb
pitch
filter
sparse
dense
diuse
high
low
input
regen
regen
low
pass
TONE VOICE
MOD DECAY MIX
ON INFINITE
hold (morph) hold (sequence)
sequence step
sequence tap
FAVORITE
LEFT IN RIGHT IN LEFT OUT RIGHT OUT EXP
MIDI IN
USB
MIDI OUTINST
LINE
9VDC
Sequence Mode (cont.)