Strymon NIGHTSKY - MIDI Specifications; MIDI PROGRAM CHANGES

NightSky - Time-Warped Reverberator
pg 36
MIDI Specifications
MIDI PROGRAM CHANGES
NightSky contains 300 preset locations, numbered sequentially from 0-299.
Because MIDI Program Change messages have a maximum number of 128
(0-127), the presets are grouped into three MIDI patch banks.
MIDI BANK 0 = PRESETS 0-127
MIDI BANK 1 = PRESETS 128-255
MIDI BANK 2 = PRESETS 256-299
NightSky always powers up in MIDI Patch Bank 0, so if you plan to stay
within the first 127 presets, simply send a standard MIDI Program
Change message to load a preset.
MIDI Program Change #’s 0-7 will illuminate the PRESET BUTTONS
GREEN to correspond with presets 1-8.
MIDI Program Change #’s 9-15 will illuminate the PRESET BUTTONS
AMBER to correspond with presets 1-8.
MIDI Program Change #’s 16-126 will NOT change the color of the
PRESET BUTTONS, but it will change the color of the FAVORITE LED
to AMBER.
If you will be using MIDI Banks 1 and/or 2, it is advisable to send a
standard MIDI Bank Change message (MIDI CC# 0 with a value equal
to the MIDI Bank#) before each MIDI Program Change.
Selecting bank 0, patch 127 will put NightSky into Manual mode. In this
mode, the pedal will be set to the current knob and button settings. No
preset data can be stored at this preset location.
NOTE: The revelant MIDI program change numbers correspond
to the MultiSwitch PLUS footswitch numbers.
MultiSwitch PLUS footswitch 1 = MIDI Program Change 1
MultiSwitch PLUS footswitch 2 = MIDI Program Change 2
MultiSwitch PLUS footswitch 3 = MIDI Program Change 3