Strymon NIGHTSKY - RUN THE SEQUENCE; SEQUENCE GLIDE

NightSky - Time-Warped Reverberator
pg 23
Sequence Mode (cont.)
NOTE: A minimum of two active steps are required for the sequence
to run.
A single press of the FAVORITE (sequence tap) footswitch resets the
sequencer to run from step 1 if the sequencer is already running. If
NightSky is receiving MIDI clock, a single press will run the sequence.
RUN THE SEQUENCE
SEQUENCE GLIDE
Tap a tempo using the FAVORITE (sequence tap) footswitch to run the
sequencer at the rate of the tapped tempo. A PRESET BUTTON LED
will illuminate RED to indicate the current step. The maximum step
length is 2000ms and the sequence will automatically run if a second
tap is not entered before the maximum step length.
Sequence Glide can be adjusted to add portamento to smooth the
changes between the sequence steps.
Press and hold the SHAPE button and turn the REVERB knob to
adjust the amount of Sequence Glide.
DRYLOW CUT HIGH CUT INTERVAL SHIMMER
REVERBSPEED DEPTH LENGTH SIZE
/ PITCH
rand
env
-8va
-5th
-2nd +2nd
+5th
+8va
-4th +4th
TARGET
FILTER GLIMMER DRIVESHIMMER
SHAPE TEXTURE QUANTIZE
pre
post
smooth
half step
scale
verb
pitch
filter
sparse
dense
diuse
high
low
input
regen
regen
low
pass
TONE VOICE
MOD DECAY MIX
ON INFINITE
hold (morph) hold (sequence)
sequence step
sequence tap
FAVORITE
LEFT IN RIGHT IN LEFT OUT RIGHT OUT EXP
MIDI IN
USB
MIDI OUTINST
LINE
9VDC
DRYLOW CUT HIGH CUT INTERVAL SHIMMER
REVERBSPEED DEPTH LENGTH SIZE
/ PITCH
rand
env
-8va
-5th
-2nd +2nd
+5th
+8va
-4th +4th
TARGET
FILTER GLIMMER DRIVESHIMMER
SHAPE TEXTURE QUANTIZE
pre
post
smooth
half step
scale
verb
pitch
filter
sparse
dense
diuse
high
low
input
regen
regen
low
pass
TONE VOICE
MOD DECAY MIX
ON INFINITE
hold (morph) hold (sequence)
sequence step
sequence tap
FAVORITE
LEFT IN RIGHT IN LEFT OUT RIGHT OUT EXP
MIDI IN
USB
MIDI OUTINST
LINE
9VDC