Strymon NIGHTSKY - Send MIDI CC; MIDI Program Change; 5 Pin DIN MIDI Through

NightSky - Time-Warped Reverberator
pg 31
Send MIDI CC
Press PRESET BUTTON 4, LED color indicates status.
Send MIDI CC On = GREEN
Send MIDI CC Off = RED (default)
MIDI Program Change
Press PRESET BUTTON 5, LED color indicates status.
Send MIDI Program Change On = GREEN
Send MIDI Program Change Off = RED (default)
5 Pin DIN MIDI Through
Press PRESET BUTTON 6, LED color indicates status.
On = GREEN (default) NOTE: Only messages generated by NightSky’s
UI are sent out of the MIDI OUT port.
Through = RED LED NOTE: MIDI messages sent to NightSky are
echoed to the MIDI OUT port without adding messages generated by
the UI.
Power Up Modes (cont.)
Global parameters and functions can be accessed via a power up
procedure. All power up functions persist through power cycles.
Press and hold the INFINITE footswitch while connecting power
to the pedal. Once the three footswitch LEDs light up, release the
footswitch.
Adjust the desired functions with the knobs and buttons noted
below.
Press any footswitch to exit power up mode.
1
2
3