Strymon NIGHTSKY - SET MIDI CHANNEL; TRS MIDI OUTPUT

NightSky - Time-Warped Reverberator
pg 30
Power Up Modes (cont.)
SET MIDI CHANNEL
Turn the REC LEVEL knob to select. ON LED indicates channel
selection.
1 = GREEN (default)
2 = AMBER
3 = RED
4-16 = BLUE (channel set by next MIDI message) With this option,
MIDI Channel is set to the channel of the next incoming MIDI
Program Change message received.
TRS MIDI OUTPUT
This determines what kind of MIDI data is sent out of NightSky’s TRS
MIDI output. Note that if you are only sending MIDI data to NightSky –
the most common configuration – the MIDI Output mode must be set
to OFF.
Turn the LENGTH knob to select, status is shown on the FAVORITE LED.
On = GREEN Only NightSky UI messages are sent out of NightSky.
Through = AMBER Incoming MIDI messages are sent to the MIDI
OUTPUT without additional MIDI messages generated by NightSky.
Off = RED (default) No MIDI Messages are sent out of NightSky.
Global parameters and functions can be accessed via a power up
procedure. All power up functions persist through power cycles.
Press and hold the INFINITE footswitch while connecting power
to the pedal. Once the three footswitch LEDs light up, release the
footswitch.
Adjust the desired functions with the knobs and buttons noted
below.
Press any footswitch to exit power up mode.
1
2
3