• If your Bluetooth enabled device does not support A2DP, it will not play the music through
the SB2140 system even after it is paired and connected successfully.
• If you are pairing and connecting your personal computer to the SB2140 using Bluetooth,
you may need to set the SB2140 as your computer’s default sound device.
RE-LINKING TO A SMARTPHONE OR BLUETOOTH ENABLED DEVICE
Even if your smartphone or Bluetooth device is already paired with the SB2140 and with both
Bluetooth functions turned on, they can become unlinked at some point due to intentional
manual disconnection or undesirable external signal interferences or over-range for more than
10 seconds. If this happens, the unit will emit two short beeps. You can re-link them and resume
play by:
1. Select “SB2140” from the device list on your smartphone or Bluetooth device. The SB2140
should re-link to your Bluetooth enabled device within 5 seconds.
2. Tap the play button of the music player on your Bluetooth enabled device to resume
playback
Bluetooth Transmitter
1. POWER on the unit, Press BLUETOOTH OUT button (except for Radio mode and
Bluetooth mode)
2. unit is in Bluetooth transmit pairing mode and BT indicator flash Green
3. Set the Bluetooth received function of your external device to ON and begin searching for
devices.
NOTE: The effective distance between your external device and this apparatus is 10 meters (30
feet)
4. Pair indicator is lighted Green steadily indicates a connection has been established
5. If you want change to pair with another Bluetooth Enable Device. Press and hold the
BLUETOOTH OUT button. The indicator will flash green and the unit will go into Pairing /
Discoverable mode again.
AUX IN OPERATION
You can play other music sources (iPod, MP3 or other digital audio players) through the
speakers of the unit by connecting the AUX IN JACK to your external player’s audio out jack or
headphone jack.
1. Plug one end of an audio cable (not included) into the AUX IN JACK and the other end of the
cable to the headphone jack of your digital audio player.
2. Slide the FUNCTION SWITCH to the CD/USB/AUX IN position.
3. Turn on and start playing the external device you plugged into the AUX IN JACK.
4. Slowly adjust both the volume controls of your unit and the external device until you reach a
comfortable listening level.
5. Turn off both the external audio player and this unit after use. Unplug the audio cable from
AUX IN jack
Notes:
• If you connect the unit to the Line-Out Jack of your external device, you only need to adjust
the VOLUME CONTROL of your unit. If you connect to the Headphone Jack of your
external device, you may need to adjust both the volume controls of your external device
and the unit to obtain the desirable listening level.
• Remember to turn off the unit when you have finished listening. Don't forget to switch off the
power of your external audio device as well.
To Next Page
Loading...
