Studer Innotec SA
BSP
10 V1.0.3 User Manual
• All components connected to this device must be conform to the laws and regulations in force. The persons
without a written authorization from Studer Innotec SA are forbidden to do any change, modification or
repair whatsoever. Regarding authorized modifications and replacements, only genuine components shall
be used.
• This device is meant for a use only indoor and must under no circumstances stand in the rain, the snow
or any other humid or dusty environment.
• In case of use in motor vehicles this device must also be protected against vibrations by absorbing
components.
1.4.3. Precautions while using batteries
Lead acid batteries with liquid electrolyte produce a highly explosive gas during normal operation. No source
of spark or of fire should be present in the closeness of the batteries. The batteries must be installed in a well-
ventilated space and mounted so as to avoid accidental short circuits while connecting them.
Never charge frozen batteries!
During any work on batteries, a second person must be present in case a problem occurs that requires
assistance. There should be within reach enough fresh water and soap for an immediate washing of the skin
or the eyes in case of accidental contact with acid. Should it happen, they must be washed carefully during
at least 15 minutes with cold water. It is then necessary to immediately consult a doctor.
To Next Page
Loading...
Need help?
General