Sub-Zero Built-in Series - Page 39

Electronic Control System
3-40
#7019014 - Revision A - October, 2010
Built-In (BI) Series
Built-In (BI) Series
Along with the temperature and index number, a thermistor location code will flash at three (3) second intervals in
the first index digit area (“r” = Refrigerator, “r” followed by “E” = Refrigerator Evaporator, “F” = Freezer, “F” followed
by “E” = Freezer Evaporator - See Figure 3-72 and 3-73).
Pressing the WARMER key (See Figure 3-74) while in Temperature Log Recall Mode will toggle up
through the
indexes, from 1 to 240, while pressing the COLDER key (See Figure 3-75) will toggle down through the indexes.
NOTE: Temperature Log Recall Mode will end twenty (20) seconds after the last key stroke.
Figure 3-73. Thermistor Location Code Flashes at 3 second intervals (F then E = Freezer Evaporator)
Figure 3-72. Thermistor Location Code Flashes at 3 second intervals (F then E = Freezer Evaporator)
PURE AIR WARMER COLDER WARMER COLDER ALARM POWER MAX ICE ICE MAKER LIGHTS
Location Code Flashes Every 3 Seconds (F=Freezer)
PURE AIR WARMER COLDER WARMER COLDER ALARM POWER MAX ICE ICE MAKER LIGHTS
Location Code Flashes Every 3 Seconds (E=Evaporator)
PURE AIR WARMER COLDER WARMER COLDER ALARM POWER MAX ICE ICE MAKER LIGHTS
Figure 3-74. Toggle UP Through Indexes - Press and Hold WARMER Key, or Press in Multiple Key Strokes
Index 002
PURE AIR WARMER COLDER WARMER COLDER ALARM POWER MAX ICE ICE MAKER LIGHTS
Figure 3-75. Toggle Down Through Indexes - Press and Hold COLDER Key, or Press in Multiple Key Strokes
Index 240
Previous Page
Main Menu
Built-In Series Menu
Built-In Series Menu
Previous Page
Main Menu
Table of Contents
Next Page
Next Page