Need help?Do you have a question about the Sub-Zero CRC-2052 and is the answer not in the manual?
General| Brand | Sub-Zero |
|---|---|
| Model | CRC-2052 |
| Category | Temperature Controller |
| Language | English |
Sets the allowable high temperature limit.
Sets the allowable low temperature limit.
Sets the differential for compressor restart.
Calibrates the room temperature probe.
Sets time delay between compressor restarts.
Sets the maximum allowed duration for defrost.
Sets the time between defrost cycles.
Sets delay for defrosting after power on.
Selects the type of defrost: Heater or Hot Gas.
Sets drip time for defrost to drain water.
Sets type of computation for defrost time.
Sets the temperature at which defrost stops.
Sets the duration for the quick freeze mode.
Sets the temperature at which the Evaporator Fan stops.
Sets the delay before the Evaporator Fan restarts.
Defines Evaporator Fan status when compressor is off.
Sets the under load limit for compressor current.
Sets the over load limit for compressor current.
Sets the limits for overvoltage faults.
Sets the limits for undervoltage faults.
To Next Page
