Sub-Zero Wolf WWD30 - Technical Data; Temperature Information

Page 30
6-2
Technical Data
WARMING DRAWER WWD30
TEMPERATURE INFORMATION
Temp. Setting Preset Temp. Approximate Preheat TimeTemp. Setting Range
HIGH
MEDIUM
LOW
PROOF
200°F
160°F
120°F
85°F
20 Minutes
15 Minutes
8 Minutes
0 - 5 Minutes
80°F - 200°F
80°F - 200°F
80°F - 200°F
(Recommended 145°F - 159°F)
80°F - 110°F
(Recommended 80°F - 100°F)
HEAT ELEMENT INFORMATION
Domestic: 850 Watts
16.9 ± 10% Ohms
NOTE: For electronic control low voltage information, see Wiring Schematic in this manual.
THERMAL CUT-OUT (TCO) INFORMATION (Auto Reset)
Open Temperature - 213.8°F ±37.4°F (101°C ± 3°C)
Close Temperature - 158°F ± 40.1°F (70°C ± 4.5°C)
POWER BOARD IDENTIFICATION (Domestic vs. International)
Domestic (120VAC 50/60Hz) - Yellow Label
International (240VAC 50/60Hz) - Green Label
THERMISTOR TESTING INFORMATION
TEMPERATURE (± 10%) OHM READING (± 10%)
65°F (18.3°C) 14.8K
68°F (20°C) 13.5K
70°F (21.1°C) 12.9K
75°F (23.9°C) 11.3K
International: 850 Watts
64.4 - 74.6 Ohms