IMPREZA(NA) A1850BE-A (ENGLISH)
2
Keys and doors
2-9
– CONTINUED –
To replace the battery:
1. Remove the two screws on the back of the trans-
mitter case by using a phillips screwdriver.
2. Separate the case.
3. Remove the old battery from the holder.
1) Positive (+) side facing up
4. Replace with a new battery (Type CR2032 or
equivalent) making sure to install the new battery
with the positive (+) side facing up.
5. Install the back half of the transmitter case.
6. Reinstall the two screws on the back of the trans-
mitter case.
After the battery is replaced, the transmitter must
be synchronized with the keyless entry system’s
control unit. Press either the “LOCK/ARM” or
“UNLOCK/DISARM” button six times to synchro-
nize the unit.
To Next Page
Loading...
