EasyManua.ls Logo

Subaru 2003 Impreza - Replacement of Brake Pad and Lining

Subaru 2003 Impreza
418 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
IMPREZA(NA) A1850BE-A (ENGLISH)
11
Maintenance and service
11-39
CONTINUED
Replacement of brake pad and lining
The front disc brakes and the right rear disc brake
have an audible wear indicators on the brake pads.
If the brake pads wear close to their service limit,
the wear indicator makes a very audible scraping
noise when the brake pedal is applied.
If you hear this scraping noise each time you apply
the brake pedal, have the brake pads serviced by
your SUBARU dealer as soon as possible.
CAUTION
If you continue to drive despite the scraping
noise from the audible brake pad wear indica-
tor, it will result in the need for costly brake
rotor repair or replacement.
J Breaking-in of new brake pads and
linings
When replacing the brake pad or lining, use only
genuine SUBARU parts. After replacement, the new
parts must be broken in as follows:
B Brake pad and lining
While maintaining a speed of 30 to 40 mph (50 to 65
km/h), step on the brake pedal lightly. Repeat this
five or more times.
B Parking brake lining
1. Drive the vehicle at a speed of about 22 mph (35
km/h).
2. With the parking brake release button pushed in,
pull the parking brake lever SLOWLY and GENTLY.
(Pulling with a force of approximately 33 lb [147 N,
15 kg].)
3. Drive the vehicle for about 220 yards (200 me-
ters) in this condition.

Table of Contents

Related product manuals