北米Model "A1470BE-A" EDITED: 2021/ 8/ 2
formed or the stereo camera lenses
are dirty.
– If there are lights similar to the
headlights or the tail lights in the
surrounding area.
– An oncoming vehicle or vehicle
ahead is driven without its headlights
and tail lights on.
– If the headlights of an oncoming
vehicle or the tail lights of a vehicle
ahead are dirty or discolored, or if the
light beams are not aimed correctly.
– A rapid change of brightness con-
tinues while driving.
– Driving on a road with many ups and
downs or uneven surfaces.
– Driving on a road with many curves.
– There are some objects that reflect
light strongly, such as a road sign or a
mirror in vehicle ahead.
– The rear part of the vehicle ahead,
such as a container, reflects light
strongly.
– The headlights of your vehicle are
damaged or dirty.
– Your vehicle is tilted, such as in case
the vehicle has a flat tire or is being
towed.
– Immediately after the hybrid system
has started.
. In the following conditions, the head-
light mode will not be automatically chan-
ged from the high beam to the low beam.
– Your vehicle passes an oncoming
vehicle suddenly in a blind curve.
– Another vehicle passes in front of
your vehicle.
– An oncoming vehicle or vehicle
ahead comes in and out of view
because of continuous curves, median
strips, roadside trees, etc.
. If the stereo camera detects the light of
the front fog lights of an oncoming vehicle,
the headlight mode may change from the
high beam to the low beam automatically.
. The headlight mode may change from
the high beam to the low beam, or the low
beam mode may continue, when affected
by a street light, traffic signal, illumination
of an advertisement board, or a reflective
object such as a road sign and signboard.
. The timing of the change of headlight
mode may differ due to the following
factors.
– Color or brightness of the headlights
of an oncoming vehicle or the tail lights
of a vehicle ahead.
– The headlights of the oncoming
vehicle or the tail lights of the vehicle
ahead are covered with mud, snow,
etc.
– Movement and direction of an on-
coming vehicle or a vehicle ahead.
– When the headlights of an oncom-
ing vehicle or the tail lights of a vehicle
ahead illuminate on only one side.
– When the oncoming vehicle or
vehicle ahead is a motorcycle.
– Conditions of a road (slope, curve,
road surface, etc.).
– Number of passengers and weight
of loaded cargo.
– Limitation of the detection ability of
the stereo camera.
& Daytime running light system
S03AH04
WARNING
When the daytime running lights are
illuminated, the tail lights do not
illuminate. When it becomes dark
outside, turn the light control switch
to the “
” position to illuminate the
headlights and tail lights. This will
improve visibility and allow other
drivers to see your vehicle more
easily.
The daytime running lights will automati-
cally illuminate when the following condi-
tions are fulfilled.
. The hybrid system is running.
. The parking brake is fully released.
. The light control switch is in “AUTO”,
“
” or “ ” (for U.S.-spec. models).
Light control switch
248
To Next Page
Loading...
Need help?
General
