北米Model "A1470BE-A" EDITED: 2021/ 8/ 2
! Return the rear seatback
S01AQ0303
WARNING
When returning the seatback to its
original position, observe the fol-
lowing precaution.
Failure to observe the precaution
may damage the seatbelt, impairing
its effectiveness, and possibly re-
sult in a serious injury.
. When returning the seatback to
its original position, pull the
seatbelt out towards the vehicle
exterior so that it will not be
caught between the seatback
and the trim.
Lock release knob
1) Unlocked
2) Locked
A) Unlocking marker in red
To return the seatback to its original
position, raise the seatback until it locks
into place and make sure that the unlock-
ing marker on the lock release knob is no
longer visible.
WARNING
When you return the seatback to its
original position, check that the
unlocking marker on the lock re-
lease knob is not visible. Also, move
the seatback back and forth to
confirm that it is securely in place.
If it is not securely fixed in place, it
may suddenly fold down in the event
of sudden braking, or objects may
move out from the cargo area. Both
could cause serious injury or death.
& Head restraints
S01AQ04
WARNING
The front seat head restraints are
designed to be installed into the
front seats only. The rear seat head
restraints are designed to be in-
stalled into the rear seats only. Do
not attempt to install the front seat
head restraints into the rear seats, or
the rear seat head restraints into the
front seats.
NOTE
It is possible to adjust the angle of the
front seat head restraints only. When
installing the front seat head restraints,
make sure that the angle of the head
restraints can be adjusted.
– CONTINUED –
Seats
83
1
Seat, seatbelt and SRS airbags
To Next Page
Loading...
Need help?
General
