Subaru EH09-2D - Page 7

– 5 –
Step Parts to remove Remarks and procedures Fasteners
8
Governor lever (1) Loosen the bolt and remove governor lever.
(2) Unhook governor spring from governor lever.
Mark the hole on which the governor
spring is hooked.
M6 x 25 : 1 pc.
10 mm box spanner
9
Carburetor (1) Disconnect choke knob from carburetor
choke lever, and remove choke bracket.
(Only for cyclone air cleaner)
(2) Remove carburetor carefully unhooking
governor rod and rod spring from
governor lever.
10
Speed control lever and
base plate
M6 x 8 : 2 pcs.
M6 x 14 : 1 pc.
10 mm box spanner
For cyclone air cleaner
GROMMET
M6 x 8 FLANGE BOLT : 2 pcs.
M6 x 14 FLANGE BOLT : 1 pc.
M6 x 25 BOLT AND
WASHER AY : 1 pc.
GOVERNOR ROD
SPEED CONTROL LEVER AY
GOVERNOR SPRING
ROD SPRING
STEP 9
STEP 8
STEP 10
FRICTION WASHER
WASHER
STOP PLATE
CHOKE KNOB
CHOKE BRACKET
GASKET
(
INSULATOR
)
GASKET
(
INTAKE
)
INSULATOR
CARBURETOR
BASE PLATE CP
GOVERNOR LEVER
P.T.O. shaft side