Subaru ER12 - Page 37

- 33 -
(9) MAIN BEARING COVER
(a) Insert the plug, suction pipe and oil pressure switch
PLUG SUCTION PIPE OIL PRESSURE SWITCH
08 - 12 N
・
m
(8 - 12
kgf
・
cm )
(06 - 09 ft
・
lb)
60- 80 N
・
m
(60 - 80 kgf
・
cm )
(43 - 58 ft
・
lb)
80 - 100 N
・
m
(80 - 100 kgf
・
cm )
(58 - 72 ft
・
lb)
(b) Apply oil to the bearing and the oil seal lip when mounting the main bearing cover Also apply sealant
(Three Bond “1280B”) to the surface of the crankcase To avoid damaging the oil seal lip, wrap the
crankshaft key-way portion with polyvinyl tape before mounting the main bearing cover

NOTE: Turn the lever portion of governor shaft does to the engine base
Tightening torque
240 - 260 N
・
m
(240 - 260
kgf
・
cm )
(177 - 188 ft
・
lb)
Also apply sealant
(Three Bond “1280B”)
to the surface.
ENGINE BASE
Turn the lever portion
of governor shaft does
to the engine base.
㻌
GOVERNOR GEAR
M8×55 FLANGE BOLT:6pcs.
GOVERNOR SHAFT
SPACER
MAIN BEARING COVER