Subaru ER12 - Page 38

- 34 -
(10) OIL PUMP and COVER
(1) Apply oil to inner and outer rotors of oil pump
and attach them in position
(2) Set O-ring in position
(3) Install oil pump cover with the allow marking
upwards
M6×12mm flange bolt : 4pcs
(11) ROCKER ARM
(a) Conduct this job at the compression top dead center
The position of two matching marks on campulley is in parallel with the cylinder head surface at a time
NOTE: Make sure that the piston is at the compression top dead center by checking mutual position
between the flywheel and the ignition coil is at the top
(b) Pass the pin (rocker arm) through the rocker arm and mount them on the cylinder head
Tightening torque
70 - 90 N
・
m
(70 - 90
kgf
・
cm )
(51 - 65 ft
・
lb)
OIL PUMP COVER
O-RING
(SYNTHETIC RUBBER)
OUTER ROTOR
ALLOW
MARKING
INNER ROTOR
MAIN BEARING COVERM6×12 FLANGE
BOLT : 4pcs.
CAMPULLEY
PIN(ROCKER)
SLIT
Matching mark
Cylinder head surface