Instruments and controls/Multi function display
6. The system will notify you that the
setting is complete.
! Bypass screen setting
1. Perform the preparation steps accord-
ing to “Preparation for screen settings”
F3-66.
2. Operate the “ ” or “ ” switch to
select the “Bypass Screen” item. Then
push the
button.
3. Select the item to set by operating the
“
” or “ ” switches. Then push the
button.
4. Select “On” or “Off” by operating the
“
” or “ ” switch. Then push the
button.
If you want to change setting for another
item, repeat steps 3 and 4.
5. Select “Set” by operating the “ ” or
3-72
To Next Page
