4. Select the preferred setting by operat-
ing the “
” or “ ” switch. Then push the
button.
5. Select “Set” by operating the “ ”
switch, and confirm the setting by pushing
the
button.
6. The system will notify you that the
setting is complete.
If the setting is not available, the following
notification will be displayed. In this case,
perform the setting procedure again.
! Rear gate unlock setting
1. Perform the preparation steps accord-
ing to “Preparation for keyless access
settings” F3-84.
2. Operate the “ ” or “ ” switch to
select the “Rear Gate Unlock” item. Then
push the
button.
Instruments and controls/Multi function display
– CONTINUED –
3-85
To Next Page
Loading...
