6-10
#7013455 - Revision A - April, 2009
Component Access/Removal
International W
International W
ine Storage
ine Storage
(ICBWS)
(ICBWS)
Series
Series
Upper Evaporator Fan Assembly
The upper evaporator fan assembly is attached to the
rear wall of the compartment with screws.
To remove the upper evaporator fan assembly, first
remove the fan cover and upper duct, then (See Figure
6-19):
1. Disconnect fan motor electrical leads.
2. Pull fan blade from fan motor shaft.
3. Extract screw from the P-clamp holding fan wires.
4. Extract fan bracket mounting screws and pull
assembly from the compartment.
5. Extract fan motor mounting screws and pull motor
from bracket.
Upper Evaporator Thermistor
The upper evaporator thermistor is inserted six to ten
inches into the opening below the third elbow on the left
side of the evaporator.
To remove the evaporator thermistor, first remove the
upper fan cover and duct, then (See Figure 6-20):
1. Pull thermistor from evaporator.
2. Cut thermistor’s wire leads six (6) to twelve (12)
inches from the back wall, then pull thermistor from
compartment.
Upper Compartment Thermistor
The upper compartment thermistor is attached to the
handle-side wall with a screw.
To remove a compartment thermistor, first remove the
upper fan cover and duct, then (See Figure 6-21):
1. Extract thermistor mounting screw.
2. Extract side cover mounting screws and pull side
cover forward while feeding thermistor through key-
hole shaped notches in cover.
3. Cut thermistor’s wire leads six (6) to twelve (12)
inches from the back wall, then pull thermistor from
compartment.
Figure 6-19. Upper Fan Assembly Removal
Fan Motor
Fan Blade
Fan Bracket
Pocket
Figure 6-20. Evaporator Thermistor Removal
Figure 6-21. Compartment Thermistor Removal
Thermistor
Side Cover
Evaporator
Thermistor
To Next Page
Loading...