Sullair 3709 - Page 36

SECTION 5
®SULLAIR®
30
3700 Operator’s Manual and Parts List
Figure 5-2
F i g u r e 5 - 2
(Figures 5-2 and 5-3) The lower line is occasionally
interrupted to descibe the compressor package’s
operating state.
Figure 5-3
F i g u r e 5 - 3
(Figure 5-4) If a machine fault occurs, the red fault “ ”
indicator will light up, and the display will indicate that a
fault has occurred.
Figure 5-4
F i g u r e 5 - 4
(Figure 5-5) The lower line periodically will display the
cause of the fault. Refer to service instructions to
correct the cause. Press the Stop pad “ ” to reset the
controller.
Figure 5-5
F i g u r e 5 - 5
(Figure 5-6) Press the Down arrow “ ” to display
additional information about the compressor. The upper
line will indicate “Compressor Status” and the name of
the temperature, pressure, or other measurement. The
lower line indicates the present reading.
Figure 5-6
F i g u r e 5 - 6
(Figure 5-7) When you continue beyond the status
information, the display will show a list of control
settings. The upper line will indicate “Show Setting” and
the name of the setting. The lower line shows the
present value.
Figure 5-7
F i g u r e 5 - 7
(Figure 5-8) To change the setting, press the Enter pad
“ ”. The display indicates that you are in a change
mode with reverse characters. Use the Up “ ” or
Down “ ” arrow keys to change the setting, and
press Enter again to save the new setting.
Figure 5-8
F i g u r e 5 - 8
(Figure 5-8) If there is no keypad activity, the display will
return to normal view in about one minute. If the Start or
Stop buttons are pressed, the display also returns to
normal view. If either of these occur, the setting will not
be altered.
If there are any warnings or recommended service
instructions, these will be periodically displayed on the
normal view.
SA_0000005
SA_0000004
SA_0000001
SA_0000002
SA_0000003
S
A_0000006
SA_0000007