Need help?Do you have a question about the Sullair TS-32S and is the answer not in the manual?
Proper use of flow-limiting valves and pressure relief procedures.
Precautions for preventing fires, managing spills, and handling ignition sources.
Safety measures related to moving components like couplings and fans.
Precautions regarding hot surfaces, sharp edges, and protective gear.
Safety guidelines for handling coolants, lubricants, and antifreeze compounds.
Electrical safety procedures for installation, maintenance, and repairs.
Safe practices for lifting, rigging, and transporting the compressor.
Detailed specifications for the TS-32S series, including dimensions and weights.
Chart detailing lubricant, fluid filter, and separator change intervals.
Requirements for compressor foundation, leveling, and frame contact.
Step-by-step procedure for the initial start-up of the compressor.
Initial maintenance tasks to remove foreign materials.
Maintenance tasks required after 1000 hours of operation.
Conditions and procedures for changing the compressor lubricant.
Replacement schedule for separator elements based on messages or time.
Detailed procedures for replacing parts and making adjustments.
Troubleshooting guide for common compressor problems and symptoms.
Proper use of flow-limiting valves and pressure relief procedures.
Precautions for preventing fires, managing spills, and handling ignition sources.
Safety measures related to moving components like couplings and fans.
Precautions regarding hot surfaces, sharp edges, and protective gear.
Safety guidelines for handling coolants, lubricants, and antifreeze compounds.
Electrical safety procedures for installation, maintenance, and repairs.
Safe practices for lifting, rigging, and transporting the compressor.
Detailed specifications for the TS-32S series, including dimensions and weights.
Chart detailing lubricant, fluid filter, and separator change intervals.
Requirements for compressor foundation, leveling, and frame contact.
Step-by-step procedure for the initial start-up of the compressor.
Initial maintenance tasks to remove foreign materials.
Maintenance tasks required after 1000 hours of operation.
Conditions and procedures for changing the compressor lubricant.
Replacement schedule for separator elements based on messages or time.
Detailed procedures for replacing parts and making adjustments.
Troubleshooting guide for common compressor problems and symptoms.
General| Model | TS-32S |
|---|---|
| Category | Air Compressor |
| Type | Rotary Screw |
| Maximum Pressure | 125 psi |
| Operating Pressure | 100 psi |
| Flow Rate | 32 CFM |
| Power Source | Electric |
| Phase | 3 Phase |
| Voltage | 230/460 V |
To Next Page
