SECTION 5 DE-18 USER MANUAL
73
M NUMBER SETTINGS
“S” Number Description Range Default Setting
M-0 CIRCLE = EXIT
M-1 LINE 1 SELECT
AN0: XXX
AN1: XXX
AN2: XXX
AN3: XXX
AN4: XXX
AN5: XXX
AN6: XXX
AN7: XXX
I1-4 XXXX
I5-12 XXXX XXXX
O1-7 XXXX XXX
195fh f00
STS:
M-2 HEX VIEW
M-3 FORCE OFF / ON
OFF
M-4 OUT FORCE
NONE / OP1(Output
1) /
OP2 / OP3 / OP4 /
OP5 /
OP6 / OP7
NONE
M-5
FACTORY SET
(This is not a 135/150 mode change, but it
does default the settings to the current mode,
the reboot is not part of this adjustment)
OFF / ON
OFF
M-6 BATT CALIB 29.5 – 33.0 (VDC)
31.3
M-7
LOAD ENABLED
If loading is disabled the Engine Start Sequence will stop
when it reaches Minimum RPM and Class “P”
shutdowns (Low P2 Pressure SD) are locked out.
NO / YES
YES
M-8
P2 AVR
Number of raw readings used for averaging of P2.
1 - 10
2
To Next Page
Loading...
