Section 3
SPECIFICATIONS
10
AMBIENT
TEMPERATURE LUBRICATION
FLUID CHANGE
PERIOD (HRS.)
FILTER CHANGE
PERIOD (HRS.)
--- 2 3 _Cto+32_C Sullube 8000 * 8000 *
Sullair LLL---4---32 8000 * 8000 *
SRF 1/4000 4000 4000
D---A Torque Fluid 1000 1000
Motor Oil MIL---2104E
SPEC API SF CC,
CD SAE 10W Class SE 600 600
Ta b l e 3 --- 1 L u b r i c a t i o n G u i d e
*8000 hours or once per year.
duced t o 300 hours maximum. A non---detergent
fluid w ith rust, oxidation and foam inhibitors and
good water separation characteristics should be
used.
WARNING
!
Mixing of other fluids within the compressor will
void all warranties.
DO NOT MIX DIFFERENT TYPES OF FLUIDS.
Contamination of non---detergent mineral fluids
with traces of ATF or detergent motor fluids may
lead to operational problems such as foaming, filter
plugging, orifice or line plugging. Flushing is re-
quired if changing to a different lubricant.
NOTE
Flush system when switching lubricant brands.
When ambient conditions exceed those noted or if
conditions warrant use of “extended” life lubricants
contact Sullair for recommendation.
Sulla ir encourages the user to participate in a fluid
analysis program. This could result in a fluid
change interval that is different from those stated in
this manual.
Figure 3 ---1 Center of Gravity
APPROXIMATELY 15.2 CM
CENTER OF GRAVITY
(MIDDLE TO RIGHT SIDE OF
CONTROL BOX)
To Next Page
Loading...
