Section 7
ILLUSTRATIONS AND PARTS LIST
29
7.3 FLUID MANAGEMENT SYSTEM
key part
number description number quantity
1 plug, hex head 1 1/16”---12 SAE 250039---359 1
2 o --- r i n g (I) 250025---419 3
3 housing, bell 250025---309 1
4 o---ring, 1 7/16” x 1/16” 826502---127 1
5 element, separator air/fluid (II) 250025---264 1
6 o---ring, 2 3/16” x 3/32” 826502---139 1
7 cap, separator element 250026---038 1
8 element, fluid filter (III) 250026---982 1
9 adapter, fluid filter 250025---914 1
10 glass, sight 250025---420 1
11 plug, thermost at 1 1/16”---12 250025---418 1
12 guide, thermostat spring 250025---417 1
13 pin, roll 1/4” x 1 1/2” 827404---150 1
14 spring, compression 250025---464 1
15 piston, thermostat 250025---415 1
16 actuator, thermostat (IV) 250025---413 1
17 capscrew, ferry hd 1/2”---13 x 3” 828408---300 12
Scapscrew, socket ISO4762 m 12 x 80 (metric) 829312---080 12
18 decal, fluid Sullube (V) 02250069---389 1
(I) F or replacement only.
(II) For maintenance on air/fluid separator element no. 250025---264, order repair kit no. 250028---033.
(III) For maintenance on fluid filter element no. 250026---982, order repair kit no. 250028---032.
(IV) For maintenance on thermostat actuator no. 250025---413, order repair kit no. 250028---036.
(V) Decal will vary with compressor fluid fill requirement. Factory fill (Sullube) decal part no. is
02250069---389.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
