Section 10
ILLUSTRATIONS AND PARTS LIST
107
10.19 ELECTRICAL CONTROLS- V-200S EXTERNALLY-MOUNTED (CONTINUED)
key part
number description number quantity
34 probe, rtd 100 ohm plat 3.5”x 12ft 250039-909 2
35 plug, straight thread 3/4-16 viton 250042-623 1
36 plug, hole n4 1/2” cond 409918-002 4
37 adapter, female pipe 1/2 x 1/4 811504-025 2
38 nut, hex pltd 5/16-18 825205-273 6
39 nut, hex pltd 3/8-16 825206-337 4
40 nut, hex pltd 7/16-14 825207-385 2
41 nut, hex pltd 1/2-13 825208-448 4
42 nut, hex metric m4 x .7 825904-070 8
43 capscr, hex gr5 5/16-18 x 1 828605-100 6
44 capscr, hex gr5 7/16-14 x 1 828607-100 2
45 capscr, hex gr5 1/2-13 x 1 1/2 828608-150 4
46 capscr, hex gr5 3/8-16 x 1 3/4 829106-175 4
47 washer, spr lock reg pltd 3/8 837806-094 4
48 washer, pl-b reg pltd 5/16 838205-071 6
49 washer, pl-b reg pltd 3/8 838206-071 8
50 washer, pl-b reg pltd 7/16 838207-071 2
51 washer, pl-b reg pltd 1/2 838208-112 4
52 washer, spr lock-metric pltd m4 838804-090 8
53 tubing, stnls stl 1/4” 20ga 841215-004 1
54 bulkhead, pipe 1/8” npt 841500-002 2
55 bushing, red pltd 1/4 x 1/8 867100-005 2
56 elbow, tube 90 deg m 1/4 x 1/8 ss 877004-012 1
57 elbow, tube 90 deg m 1/4 x 1/4 ss 877004-025 1
58 adapter, expand 1/8-27f x 1/8-27m 879302-002 2
59 breaker, circtl high inrush (I) -3
60 contactor, ac 3p 120v chf (I) -1
61 transformer, control univ.volt (cb) (I) -1
62 transformer, control univ.volt (fused) (I) -1
63 cutler hammer vsd (I) -1
64 fuse, limitron ktk-r (I) -1
65 fuse, kldr (I) -2
66 starter, man mtr prot ab (I) -1
(I) This part may vary per machine design. Consult factory with machine serial number to determine the
proper part number.
PLEASE NOTE: WHEN ORDERING PARTS, INDICATE SERIAL NUMBER OF COMPRESSOR
To Next Page
Loading...
