Need help?Do you have a question about the Sullair Supervisor II Deluxe Controller and is the answer not in the manual?
General| Microprocessor | 32-bit |
|---|---|
| Power Supply | 24 VDC |
| Mounting | Panel Mount |
| Communication Ports | RS-485, Ethernet |
| Storage Temperature | -40°C to 85°C |
| Input Voltage | 24 VDC |
| Communication Protocol | Modbus RTU/TCP |
| Enclosure Rating | IP65 |
General safety measures and warnings for operators and parameter changes.
Procedures for enabling Supervisor, Supervisor II, and WS controllers in sequencing mode.
Steps for preparing machines, including calibration, COM ID, and parameter settings.
Details system setup and tuning parameters for low pressure sequencing configurations.
Provides step-by-step instructions for modifying sequence parameter settings on the Supervisor Controller.
Details how to change sequence parameters for Supervisor II Deluxe and WS controllers.
Procedures for temporarily disabling and then restoring a machine to the sequence for maintenance.
Step-by-step guide to calibrate the P2 pressure transducer for the Supervisor Controller.
Detailed steps for calibrating the P2 pressure transducer on the Supervisor II Deluxe controller.
Instructions for calibrating the WS Controller P2 pressure transducer via PC interface.
Details setup for systems combining fixed-speed machines with a VSD compressor.
Configuration steps for systems with multiple variable speed drive compressors.
Explains the function of Recovery and Delayed Start timers for system efficiency and demand response.
To Next Page
