Need help?Do you have a question about the Sullair WS CONTROLLER and is the answer not in the manual?
General| Display | LCD |
|---|---|
| Operating Temperature | 0° to 50°C (32° to 122°F) |
| Power Supply | 24 VDC |
| Communication Ports | RS-485 |
| Input Voltage | 24 VDC |
| Communication Protocol | Modbus RTU |
General safety precautions for operators and maintenance personnel.
Explains the concept and benefits of compressor sequencing systems.
How to enable and operate controllers in a sequencing system.
Details sequencing modes like Sequence Hours and Com Num.
Describes control signal wiring for Supervisor, Supervisor II Deluxe, and WS Controllers.
Steps to prepare machines before connecting them to a sequence.
Details settings for low pressure systems and table of typical settings.
Importance of calibrating pressure transducers for system stability.
Step-by-step guide to calibrate P2 pressure on Supervisor Controller.
Step-by-step guide to calibrate P2 pressure on Supervisor II Deluxe Controller.
How to calibrate P2 pressure on WS Controller using PC software.
Explains the function of Recovery and Delayed Start timers for system efficiency.
To Next Page
