Sullair WSPC - Access Privileges; Starting the Software

Section 3
13
WSPC USER INTERFACE MANUAL
GETTING STARTED
3.1 ACCESS PRIVILEGES
The WSPC User Interface program may be
accessed at two levels.
User Level: Allows users to access the program
without entering a password. The user should be an
individual with specific authorization to use the
WSPC software and knowledge of the compressor
operation. This level includes all data and
adjustments for normal applications of the
compressor. At this level a user has access to the
following displays: Compressor Data, Machine Info,
Service, Maintenance, Sequencing, and
Adjustments.
Administrator Level: This provides additional
functions for maintenance, service, and setup for
trained compressor technicians. Administrator level
functions are described in Part 2 of this manual. A
password is required to access this level.
3.2 STARTING THE SOFTWARE
1. Click the shortcut located on the computer
desktop to start the WSPC User Interface
program.
2. When the program opens, a dialog box will
appear as shown in Figure 3-1. Click OK to
open the WSPC program. If the program
was last closed while operating at the
Administrator level the dialog box will require
a password as shown in Figure 3-2.
Do the following to select a user-level profile:
A. Click the down arrow next to the “User Name”
box. A drop-down list of user profiles will be pre-
sented. See Figure 3-3.
B. Click on a profile that is set for “User Level”
access (Default User) and click “OK”. User level
profiles do not require password access. More
profile options may be available in the User
Name list than the ones shown in Figure 3-3.
Figure 3-1: WSPC User Interface password
request
Figure 3-2: WSPC User Interface password
request