SECTION 7 WSPC USER INTERFACE MANUAL
59
7.5 ADMINISTRATOR
ADJUSTMENTS (ADMIN)
DISPLAY
The Administrator Adjustments (Admin) display tab is
available only when an administrator level profile is
active. This display allows the administrator to edit
the ID’s of specific controller inputs and to make zero
calibration adjustments of measured values between
the compressor system and the controller. The
Admin user can view the current assignments of the
controller input registers and make adjustments as
necessary. See Figure 7-10. The inputs shown in the
figure are for reference and vary based on specific
machine configurations.
Changes can only be made at the Admin display
while the compressor is stopped. When the
compressor is running, the fields of the Admin
display are inactive. Changes made at the Admin
display will be applied to the WS Controller within a
few seconds after entry. Some changes may not be
shown properly on WSPC. To ensure correct
information, always click the "Connect" button when
finished with this page to disconnect from the
controller. Click "Connect" again to reconnect and
update the WSPC displays.
Figure 7-9: Maintenance History Window
To Next Page
Loading...