WSPC USER INTERFACE MANUAL SECTION 7
60
Described below are parameters that can be edited
by the Administrator at the “Admin” display. The units
and language appearing in the “Administrator
Adjustment” display correspond to the settings
applied when the Administrator profile was created.
SIGNAL ADDRESS FUNCTION
Refer to Figure 7-10. The left section contains a list
of controller functions, and allows selection of signals
to operate the function. This allows special field
setups for special applications.
General Fault—Generates an Option Input Fault
when on.
General Warning—Generates User Option Warning
when on.
General Runtime Fault—Generates an Option Input
Run Fault when on. This fault is enabled a few
seconds after the compressor starts.
General Runtime Warning—Generates a User
Option Warning when on. This warning is enabled a
few seconds after the compressor starts.
Remote Operate—Operates the compressor when
on. Remote Master – Uses Remote inputs when on.
Remote Unload—Forces the compressor to unload
when on. Refer to the Sequencing manual for details
on using the remote inputs.
Dryer Warning—Generates Dryer Warning when
on.
Dryer Fault—Generates Dryer Fault when on.
Phase Monitor Fault—Generates Phase Monitor
Fault when on.
Water Pressure Fault—Generates Water Pressure
Fault when on.
Factory-Defined A through E—Operates the
factory defined relay when on. Actual relay
assignments are shown, and depend on compressor
model.
Figure 7-10: Administrator Adjustment Display
To Next Page
Loading...