3 Serial No.
COMMON
1. Inspection Upon Delivery
CAUTION
Make sure that the unit is positioned right side up before unpacking. Otherwise, injury may occur.
Make sure that the unit agrees with your order. Injury or damage to the equipment may occur by using the
incorrect product.
Do not remove the nameplate from the unit.
Make sure of the following when this product arrives.
1. Do the items shown on nameplate agree with the order?
2. Was there no damage during transportation?
3. Are all bolts and nuts tightened firmly?
Consult our agent, distributor, or sales office for any defect or questions.
1-1) Inspection of the Nameplate
Gearmotor
Fig. 1 Nameplate of Gearmotor
Reducer
Fig. 2 Nameplate of Reducer
1-2) Inspection of Lubrication Method
Make sure of the lubrication method by referring to section "8-2. Lubrication Method" on page 24.
• Oil lubrication models are shipped with out oil. Always supply the unit with recommended oil before operation.
• Oil supply for two places is necessary for some models for output side and input side, (such as
combination of BUDDYBOX and CYCLO).
COMMON
Nameplate of Gear Nameplate of Motor
• Let us know the (1) Nomenclature of gearmotor or reducer, (2) reduction ratio, and (3) serial number when
consulting us.